zCONNECT Z-Wave Wireless Water & Irrigation Control Valve (20 mm / 0.75″)

Designed and assembed in Australia the zConnect Z-WAVE wireless water valve is an electromechanical device with a motor and Z-Wave control module with two-way ball valve that can be remotely or manually controlled to open / close water pipes. Comes in dimension 15 mm (1/2 – inch) or 20 mm (3/4 – inch) so please choose the right size for your pipes.

Prevent floods/water damage and use this z-wave wireless water valve to turn off mains water automatically when certain condittions occur e.g. water leak is detected using sensors like?Fibaro water sensor (not included). Also designed to be used as part of irrigation system so you can automatically turn on/off the sprinklers or watering system anytime from anywhere.

This zConnect water valve is designed for residential and light commercial usage and integrates with Z-Wave smart home automation systems such as VeraEdge/VeraPlus, Fibaro HC2/Lite or similar.

For irrigation solutions this device can be added to ?Z-Wave Fibaro Home Center 2 in the sprinklers panel so you can schedule all sprinklers in your garden to automatically turn on and off.

Z-Wave intelligence for your gardens and lawns

Avoid costly, accidental flooding of your home

Install this zConnect Z-Wave Water Valve and combine it with Fibaro Flood Sensors to automatically shut off water supply at the first sign of a leak or rupture.

Product Details

zConnect Z-WAVE WIRELESS WATER VALVE is an electromechanical device with a motor, Z-Wave control module and two-way ball valve that can be remotely or manually controlled to open / close water pipes.

This valve can be operated manually as well, which gives the ability to open and close the valve even in the absence of electricity.

• Dimension 20 mm (3/4 inch) or15 mm (1/2 – inch)
• Powered by 240V mains so electrican install only (not DIY)
• zConnect Z-WAVE WIRELESS WATER VALVE has onboard Z-Wave chip
• Low voltage electric motor
• IP-65 protection
• Remote capability through gateways
• Industrial quality ball valve
• Z-Wave 500 series chip
• Pipe size 15mm (1/2”)
• Manual override
• Supports the Over the Air (OTA) feature for the product’s firmware upgrade (subject availability on your Z-Wave Gateway).
• Designed and assembled in Australia.

Product Support

Please note:?If you are installing the entire Z-Wave system for the first time, please refer to the installation guide of your Z-Wave gateway before installing this device.

Please note:

BEFORE INSTALLING THE VALVE IT IS NECESSARY TO CHOOSE THE RIGHT PLACE OF INSTALLATION AND TO PROVIDE THE POWER FOR THE DEVICE. IN AUSTRALIA, THE INSTALLATION OF THIS PRODUCT MUST BE CARRIED OUT IN AN APPROVED MANNER BY A SUITABLE QUALIFIED PLUMBING/ELECTRICAL CONTRACTOR IN ACCORDANCE WITH AS/NZS3000.

Manuals:

Installation Manual (Size: 1.67Mb)